Dell S4048T, Руководство по настройке

Страница: 861 / 1277

On ECN deployment, the non-ECN packets that are transmitted on the ECN-WRED enabled interface will be
considered as Green packets and will be subject to the early WRED drops. Typically the TCP-acks, OAM, ICMP
ping packets will be non-ECN in nature and it is not desirable for this packets getting WRED dropped.
In such a condition, it is necessary that the switch is capable to take differentiated actions for ECN/Non-ECN
packets. After classifying packets to ECN/Non-ECN, marking ECN and Non-ECN packets to different color
packets is performed.
Policy based ingress QOS involves the following three steps to achieve QOS:
1 Classification of incoming traffic.
2 Specify the differentiated actions for different traffic class.
3 Attach the policy-map to the interface.
Dell Networking OS support different types of match qualifiers to classify the incoming traffic.
Match qualifiers can be directly configured in the class-map command or it can be specified through one or
more ACL which in turn specifies the combination of match qualifiers.
Until Release 9.3(0.0), support is available for classifying traffic based on the 6-bit DSCP field of the IPv4
packet.
As a part of this feature, the 2-bit ECN field of the IPv4 packet will also be available to be configured as one of
the match qualifier. This way the entire 8-bit ToS field of the IPv4 header shall be used to classify traffic.
The Dell Networking OS Release 9.3(0.0) supports the following QOS actions in the ingress policy based
QOS:
1 Rate Policing
2 Queuing
3 Marking
For the L3 Routed packets, the DSCP marking is the only marking action supported in the software. As a part
of this feature, the additional marking action to set the “color” of the traffic will be provided.
Until Release 9.3(0.0), the software has the capability to qualify only on the 6-bit DSCP part of the ToS field in
IPv4 Header. You can now accept and process incoming packets based on the 2-bit ECN part of the ToS field
in addition to the DSCP categorization. The IPv4 ACLs (standard and Extended) are enhanced to add this
qualifier. This new keyword ‘ecn’ is present for all L3 ACL types (TCP/UDP/IP/ICMP) at the level where the
‘DSCP’ qualifier is positioned in the current ACL commands.
Dell Networking OS supports the capability to contain DSCP and ECN classifiers simultaneously for the same
ACL entry.
You can use the ecn keyword with the ip access-list standard, ip access-list extended, seq, and permit
commands for standard and extended IPv4 ACLs to match incoming packets with the specified ECN values.
Similar to ‘dscp’ qualifier in the existing L3 ACL command, the ‘ecn’ qualifier can be used along with all other
supported ACL match qualifiers such as SIP/DIP/TCP/UDP/SRC PORT/DST PORT/ ICMP.
Until Release 9.3(0.0), ACL supports classification based on the below TCP flags:
Quality of Service (QoS) 861