Dell S4048T, Руководство по настройке

Страница: 1130 / 1277

PROTOCOL SPANNING TREE RSTP mode
no disable
3 Configure each peer switch with a unique bridge priority.
PROTOCOL SPANNING TREE RSTP mode
bridge-priority
Sample RSTP Configuration
The following is a sample of an RSTP configuration.
Using the example shown in the Overview section as a sample VLT topology, the primary VLT switch sends
BPDUs to an access device (switch or server) with its own RSTP bridge ID. BPDUs generated by an RSTP-
enabled access device are only processed by the primary VLT switch. The secondary VLT switch tunnels the
BPDUs that it receives to the primary VLT switch over the VLT interconnect. Only the primary VLT switch
determines the RSTP roles and states on VLT ports and ensures that the VLT interconnect link is never
blocked.
In the case of a primary VLT switch failure, the secondary switch starts sending BPDUs with its own bridge ID
and inherits all the port states from the last synchronization with the primary switch. An access device never
detects the change in primary/secondary roles and does not see it as a topology change.
The following examples show the RSTP configuration that you must perform on each peer switch to prevent
forwarding loops.
Configure RSTP on VLT Peers to Prevent Forwarding Loops
(VLT Peer 1)
Dell_VLTpeer1(conf)#protocol spanning-tree rstp
Dell_VLTpeer1(conf-rstp)#no disable
Dell_VLTpeer1(conf-rstp)#bridge-priority 4096
Configure RSTP on VLT Peers to Prevent Forwarding Loops
(VLT Peer 2)
Dell_VLTpeer2(conf)#protocol spanning-tree rstp
Dell_VLTpeer2(conf-rstp)#no disable
Dell_VLTpeer2(conf-rstp)#bridge-priority 0
Configuring VLT
To configure VLT, use the following procedure.
Prerequisites:
Virtual Link Trunking (VLT) 1130