Dell S4048T, Руководство по настройке

Страница: 444 / 1277

Handling of Management Route Configuration
When the EIS feature is enabled, the following processing occurs:
• All existing management routes (connected, static and default) are duplicated and added to the
management EIS routing table.
• Any management static route newly added using the
management route
CLI is installed to both the
management EIS routing table and default routing table.
• As per existing behavior, for routes in the default routing table, conflicting front-end port routes if
configured has higher precedence over management routes. So there can be scenarios where the same
management route is present in the EIS routing table but not in the default routing table.
• Routes in the EIS routing table are displayed using the
show ip management-eis-route
command.
• In the netstat output, the prefix “mgmt” is added to routes in the EIS table so that the user can
distinguish between routes in the EIS Routing table and default routing table.
• If the management port IP address is removed, the corresponding connected route is removed from
both the EIS routing table and default routing table.
• If a management route is deleted, then the route is removed from both the EIS routing table and default
routing table.
Handling of Switch-Initiated Traffic
When the control processor (CP) initiates a control packet, the following processing occurs:
• TCP/UDP port number is extracted from the sockaddr structure in the in_selectsrc call which is called as
part of the connect system call or in the ip_output function. If the destination TCP/UDP port number
belongs to a configured management application, then sin_port of destination sockaddr structure is set
to Management EIS ID 2 so that route lookup can be done in the management EIS routing table.
• To ensure that protocol separation is done only for switch initiated traffic where the application acts as
client, only the destination TCP/UDP port is compared and not the source TCP/UDP port. The source
TCP/UDP port becomes a known port number when the box acts as server.
• TFTP is an exception to the preceding logic.
• For TFTP, data transfer is initiated on port 69, but the data transfer ports are chosen independently by
the sender and receiver during initialization of the connection. The ports are chosen at random
according to the parameters of the networking stack, typically from the range of temporary ports.
• If route lookup in EIS routing table succeeds, the application-specific packet count is incremented. This
counter is viewed using the
show management application pkt-cntr
command. This counter is
cleared using
clear management application pkt-cntr
command.
• If the route lookup in the EIS routing table fails or if management port is down, then packets are
dropped. The application-specific count of the dropped packets is incremented and is viewed using the
show management application pkt-drop-cntr
command. This counter is cleared using
clear
management application pkt-drop-cntr
command.
Internet Group Management Protocol (IGMP) 444