Dell S4048T, Руководство по настройке

Страница: 827 / 1277

Port Cost Default Value
Port Channel with 1-Gigabit Ethernet interfaces 18000
Port Channel with 10-Gigabit Ethernet interfaces 1800
Port Channel with 25-Gigabit Ethernet interfaces 1200
Port Channel with 50-Gigabit Ethernet interfaces 200
Port Channel with 100-Gigabit Ethernet interfaces 180
NOTE: The Dell Networking OS implementation of PVST+ uses IEEE 802.1s costs as the default costs.
Other implementations use IEEE 802.1w costs as the default costs. If you are using Dell Networking
systems in a multi-vendor network, verify that the costs are values you intended.
To change the port cost or port priority of an interface, use the following commands.
• Change the port cost of an interface.
INTERFACE mode
spanning-tree pvst vlan cost
.
The range is from 0 to 200000.
Refer to the table for the default values.
• Change the port priority of an interface.
INTERFACE mode
spanning-tree pvst vlan priority
.
The range is from 0 to 240, in increments of 16.
The default is 128 .
The values for interface PVST+ parameters are given in the output of the
show spanning-tree pvst
command, as previously shown.
Configuring an EdgePort
The EdgePort feature enables interfaces to begin forwarding traffic approximately 30 seconds sooner.
In this mode an interface forwards frames by default until it receives a BPDU that indicates that it should
behave otherwise; it does not go through the Learning and Listening states. The
bpduguard shutdown-on-
violation
option causes the interface hardware to be shut down when it receives a BPDU. When you only
implement
bpduguard
, although the interface is placed in an Error Disabled state when receiving the BPDU,
the physical interface remains up and spanning-tree drops packets in the hardware after a BPDU violation.
BPDUs are dropped in the software after receiving the BPDU violation.
This feature is the same as PortFast mode in spanning tree.
CAUTION: Configure EdgePort only on links connecting to an end station. EdgePort can cause loops if
you enable it on an interface connected to a network.
To enable EdgePort on an interface, use the following command.
Per-VLAN Spanning Tree Plus (PVST+) 827