Dell S4048T, Руководство по настройке

Страница: 1104 / 1277

2 Active T Po1(So 0/0-1)
T Te 1/1
3 Active T Po1(So 0/0-1)
T Te 1/2
4 Active T Po1(So 0/0-1)
When you remove a tagged interface from a VLAN (using the
no tagged interface
command), it remains
tagged only if it is a tagged interface in another VLAN. If the tagged interface is removed from the only VLAN
to which it belongs, the interface is placed in the Default VLAN as an untagged interface.
Moving Untagged Interfaces
To move untagged interfaces from the Default VLAN to another VLAN, use the following commands.
1 Access INTERFACE VLAN mode of the VLAN to which you want to assign the interface.
CONFIGURATION mode
interface vlan vlan-id
2 Configure an interface as untagged.
INTERFACE mode
untagged interface
This command is available only in VLAN interfaces.
Move an Untagged Interface to Another VLAN
The
no untagged interface
command removes the untagged interface from a port-based VLAN and
places the interface in the Default VLAN. You cannot use the
no untagged interface
command in the
Default VLAN. The following example shows the steps and commands to move an untagged interface from
the Default VLAN to another VLAN.
To determine interface status, use the
show vlan
command. Interface (1/2) is untagged and in the Default
VLAN (vlan 1). In a port-based VLAN (vlan 4), use the
untagged
command to add the interface to that VLAN.
The
show vlan
command output displays the interface’s changed status (1/2). Because the Default VLAN no
longer contains any interfaces, it is listed as inactive.
Dell# show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM Status Q Ports
* 1 Active U Te 1/2
2 Active T Po1(So 0/0-1)
T Te 1/3
3 Active T Po1(So 0/0-1)
T Te 1/1
4 Inactive
Dell#conf
Dell(conf)#interface vlan 4
Dell(conf-if-vlan)# untagged tengigabitethernet 1/2
Dell(conf-if-vlan)#show config
!
interface Vlan 4
no ip address
untagged TenGigabitEthernet 1/2
Dell(conf-if-vlan)#end
Virtual LANs (VLANs) 1104