Dell OptiPlex GX100, Руководство пользователя

Страница: 36 / 107

5. Remove the drive bracket from the chassis.
a. If a drive is already installed in the bracket, disconnect the power and interface cables from the back of the drive.
b. Squeeze the tabs on each side of the drive bracket, and slide it forward about one inch (see Figure 2).
Figure 2. Removing the Hard-Disk Drive Bracket From the Small-Form-Factor Chassis
c. Lift the drive bracket away from the chassis.
d. If a drive is already installed in the bracket, remove the four screws securing the drive to the bottom of the bracket (see Figure 3).
Figure 3. Removing a Hard-Disk Drive From the Hard-Disk Drive Bracket
6. Secure the new drive to the drive bracket with four screws (see Figure 3).
7. Reinstall the hard-disk drive bracket in the chassis.
a. Place the bracket so that the release tabs extend about one inch past the front of the chassis, and align the tabs on the bottom of the
bracket with the hooks on the chassis floor.
b. Then slide the bracket toward the back of the chassis until the tabs snap under the hooks (see Figure 4). The bracket release tabs
should also snap into the front of the chassis.
Figure 4. Reinstalling the Hard-Disk Drive Bracket in the Small-Form-Factor Chassis
1 Drive shelf
2 Release tabs (2)
1 Drive bracket
2 Release tabs (2)
1 Drive
2 Drive bracket
3 Screws (4)