Dell Inspiron 531, Руководство пользователя

Страница: 177 / 212

Appendix
177
5
Replace the computer cover (see "Replacing the Computer Cover" on page 164).
NOTICE:
To connect a network cable, first plug the cable into the network device
and then plug it into the computer.
6
Connect your computer and devices to electrical outlets, and turn them on.
Clearing CMOS Settings
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions located in the Product Information Guide .
1
Follow the procedures in "Before You Begin" on page 97.
NOTE:
The computer must be disconnected from the electrical outlet to clear
the CMOS setting.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 99).
3
Reset the current CMOS settings:
a
Locate the 3-pin CMOS jumper (CLEAR CMOS) on the system
board (see "System Board Components" on page 102).
b
Remove the jumper plug from the CMOS jumper (CLEAR CMOS)
pins 2 and 3.
c
Place the jumper plug on the CMOS jumper (CLEAR CMOS) pins 1
and 2 and wait approximately five seconds.
d
Remove the jumper plug and replace it on the CMOS jumper
(CLEAR CMOS) pins 2 and 3.
4
Replace the computer cover (see "Replacing the Computer Cover" on
page 164).
NOTICE:
To connect a network cable, first plug the cable into the network port or
device and then plug it into the computer.
5
Connect your computer and devices to electrical outlets, and turn
them on.
book.book Page 177 Friday, April 4, 2008 12:10 PM