Dell E56S Series, Инструкция по установке и обслуживанию

Страница: 84 / 154

Figure 65. Installing the heat sink onto the processor
Next steps
1. Install the processor and heatsink .
2. If removed, install the risers .
3.
4.
Install the air shroud .
5. Install the system cover .
6. Place the system into the rack. For more information, see the Rail Installation Guide at www.dell.com/xcseriesmanuals .
7. Open the drive bays , install all drives , and then close the drive bays .
8. Install the power supply units .
9. Follow the procedure listed in After working inside your system .
Installing a processor and heat sink module
Prerequisites
CAUTION: Never remove the heat sink from a processor unless you intend to replace the processor. The heat sink is
necessary to maintain proper thermal conditions.
1. Follow the safety guidelines listed in Safety Instructions .
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5.
Open the drive bays , remove all drives , and then close the drive bays .
6. Remove the power supply units .
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/xcseriesmanuals .
8. Remove the system cover .
84 Installing and removing system components