Dell E56S Series, Инструкция по установке и обслуживанию

Страница: 101 / 154

Figure 90. Installing butterfly riser
Next steps
1.
2.
Install the air shroud .
3. Install the system cover .
4. Place the system into the rack. For more information, see the Rail Installation Guide at www.dell.com/xcseriesmanuals .
5. Open the drive bays , install all drives , and then close the drive bays .
6. Install the power supply units .
7. Install any device drivers required for the card as described in the documentation for the card.
8. Follow the procedure listed in
After working inside your system .
M.2 SSD module
Removing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in Safety Instructions .
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4.
Open the drive bays , remove all drives , and then close the drive bays .
5. Remove the power supply units .
6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/xcseriesmanuals .
7. Remove the system cover .
8. Remove the air shroud .
9. Remove the BOSS card .
10.
NOTE: The procedure to remove the BOSS card is similar to the remove an expansion card.
Installing and removing system components 101