Dell E56S Series, Инструкция по установке и обслуживанию

Страница: 45 / 154

Next steps
Replace the internal PERC riser .
Installing the internal PERC riser
Prerequisites
1. Follow the safety guidelines listed in Safety Instructions .
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5.
Open the drive bays , remove all drives , and then close the drive bays .
6. Remove the power supply units .
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/xcseriesmanuals .
8. Remove the system cover .
9. Remove the air shroud .
Steps
1. Connect the cable connector to the internal PERC card by aligning it to the guiding pins and replace the screws using a Phillips #2
screwdriver.
Figure 22. Connecting the cable to internal PERC riser
2. Turn over the internal PERC riser and align the internal PERC riser to the PCI slot by holding the blue touch points, and press until fully
seated.
3. Lift the plunger to lock the riser in place.
Installing and removing system components 45