DELAIR UX11, Руководство пользователя, Страница: 39 / 94

User Manual UX11
Note
It is recommended to leave this option checked.
Note
If area cannot be completed in a single flight, the software estimate a termination point for the
flight. Flight lines that cannot be achieved are grayed out. Landing is automatically connected
to termination point. Each time flight plan is modified termination point is updated. Moving
take-off and landing may increase flight time and change termination point. Uncovered area
may be completed by resuming flight plan, see Managing the flight settings on page 28
5.4.2 Set the takeoff location
1 Tap on the map to add a takeoff location.
The takeoff location and some waypoints indicating the route of the UX11 from the takeoff point
to the start of the area flight path are shown.
2 Verify that a couple of waypoints have been created automatically. You can move them by
touching and dragging the waypoints so that the trajectory entering the flight plan is acceptable.
3 To reposition the takeoff spot, tap and move it on the map.
4 Tap DONE or Next .
5.4.3 Set the landing location
The landing location can be set beforehand. You can also set the landing location just before the flight,
see Finishing the creation of the flight plan on page 43 .
Note
The landing position must be selected in a way that the ground is relatively flat 40 m (131 ft) before
landing and that the landing area is suited for landing (no obstacles or inappropriate surface), see Obstacle
clearances on page 22 .
1 Tap on the map to add a landing location or move to desired location and press Here button
(tablet GPS must be enabled).
The landing location and some waypoints indicating the route of the UX11 from the end of the
area flight path to the landing location are shown.
2 To edit the landing route, tap and drag the waypoints on the map.
3 To reposition the landing spot, tap and move it on the map.
Note
It may be necessary to use an altitude offset if the landing position differs from the aircraft power up
position. See section Completing the pre-flight checklist on page 47 .
4 Select Heading linked to wind .
5 Select the direction of the entry circle:
Delair | 676, Rue Max Planck – 31670 Toulouse-Labège, France | Tel: +33 (0) 5 82 95 44 06 | www.delair.aero
Capital: 238 110,30 € - APE: 3030Z – Intra-Community VAT number: FR90 53 09 69 781 – 530 969 781 R.C.S. Toulouse
This document is the sole property of Delair and cannot be used or reproduced without the written authorization of Delair.
30