Datasat RS20i, Инструкция по установке и эксплуатации

Страница: 25 / 139

RS20i Installation and Operating Guide Page 25
RS20i Installation & Operating Guide Document # 9301H52900 Ver. 1.00
2.0 Installation and Set Up
Important Safety Instructions
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
9) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding type plug has two blades and a third grounding
prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit
into your outlet, consult an electrician for replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.
11) Only use attachments/accessories specified by the manufacturer.
12) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer,
or sold with the apparatus. When a cart is used, use caution when moving the
cart/apparatus combination to avoid injury from tip-over.
13) Unplug this apparatus during lightning storms or when unused for long periods of time.
14) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate
normally, or has been dropped.
2.1 Installation Checklist
This checklist summarizes the installation and setup procedures for the RS20i.
Table 2: RS20i Installation and Setup
Completed Task Description Refer to:
VERIFY INPUT VOLTAGE
Verify correct 115 or 230V input voltage
selection at the rear panel power entry
module. Power Supply, page 31
PREPARE RS20i FOR RACK
Install rack ears on RS20i, if mounting in
Equipment Rack.
3
Chassis Rack Mounting and Connection,
page
3
29