DataKinetics DSC110 / DSC210 User Manual Issue 12
Page 148
7.23.13 Routing Point of Origin Change
RTPOC
Routing Point of Origin Change
This command is used to change the attributes in a point of origin.
Syntax
RTPOC:POR=,
[DAI=,][DOGR=,][SPOR=,],[DAMD=,][CDST=,][CDDL=,][CDPRE=,]
[CGMD=,][CGDL=,][CGPRE=,][CPCD=,][CPCG=,][CG2PRE=,]
[CG2DL=,][LCMD=,][RCG=,][ISM=,][LSTAB=,][LSM=,]
[ISTAB=,][LABEL=,];
Prerequisites
If an outgoing route, secondary point of origin digit analysis index, calling party
number profile or called party number profile are specified then they must
have already been initiated.
Either a digit analysis index, default outgoing route or secondary point of
origin must exist as a result of this command.
Both a default outgoing route and secondary point of origin cannot exist as a
result of this command.
A specified secondary point of origin cannot cause a routing loop that results
in the original point of origin specified in this command.
If a digit analysis index, secondary point of origin or default outgoing route are
specified the point of origin must not currently route to a circuit mapped group
where either it or its partner is unblocked.
If the local service mode is greater than 0 then the local service control table
must also be greater than 0. If the calling party number mode equals 0 then
the local service control table must also equal 0.
ISM can only be set to a value other than 0 if ISC is set to Y by the configure
system command.
N.B. When an incoming circuit group from a route is Japan TTC ISUP and
CG2PRE is set the digits from the CG2PRE will form the carrier information
code sent in the ACM. The user should not set CGMD=2 when the point of
origin comes from an outgoing Japan TTC ISUP circuit group.
Limitations
Routing from a point of origin can only result in up to 5 secondary points of
origin before achieving an outgoing route.
Attributes CONFIG
Example RTPOC:POR=1,DAI=2,CGMD=1,CGDL=5,CGPRE=01425;
