DataKinetics DSC110, Руководство пользователя

Страница: 116 / 202

DataKinetics DSC110 / DSC210 User Manual Issue 12 Page 116
7.18.10 CCS SS7 Signalling Link Change
C7SLC CCS SS7 Signalling Link Change
This command is used to change the attributes of an SS7 signalling link.
Syntax C7SLC:C7LINK=,{[EQU=,][TS=,][M56K=,][PCR=,]};
Prerequisites
The specified link has already been initiated.
The specified PCM time slot is not already assigned elsewhere in the system.
The PCM on which the timeslot exists has been initiated.
If specified, the Board on which the EQU exists has been initiated.
If specified, the PCM on which the timeslot exists has been initiated.
The timeslot is a valid timeslot number for the PCM type (up to 31 for a E1 PCM
and 24 for a T1 PCM).
The signalling processor specified by the EQU parameter must be equipped with a
valid board type and not already assigned to a link.
The signalling link must be blocked.
If the EQU is specified the board given within the EQU must be blocked.
All links within the linkset must be blocked.
If M56K is set to either 1 or 2 then all links on the same board for which M56K is set
to 1 or 2 must also use the same M56K value (i.e. Only one mode of 56kbits/s
operation is supported on any board at one time. However it is possible for some
links to operate at 64kbits/s whilst others operate at 56kbits/s).
Attributes CONFIG
Example C7SLC:C7LINK=4,EQU=2-1,TS=5-1-17,M56K=1;
7.18.11 CCS SS7 Signalling Link End
C7SLE CCS SS7 Signalling Link End
This command is used to end an SS7 signalling link.
Syntax C7SLE:C7LINK=;
Prerequisite The signalling link must be blocked.
The signalling link must not be monitored.
Attributes CONFIG
Example C7SLE:C7LINK=1;