X64 Xcelera-HS PX8 User's Manual
X64 Xcelera-HS PX8 Reference
•
51
trash buffer, which is defined as the last buffer in the list; otherwise it will occur in the next
buffer. After a transfer to the trash is done, the transfer device will check the next buffer in
the list, if its state is empty, it will transfer to this buffer otherwise it will skip it, and
transfer again to the trash buffer.
•
CORXFER_VAL_CYCLE_MODE_ASYNCHRONOUS
The transfer device cycles through all buffers in the list without concern about the buffer
state.
Output LUT Availability
The following table defines the supported output LUT (look up tables) for the X64 Xcelera-HS PX8.
Note that unsupported modes are not listed.
Number of Bits
Output Pixel Format
LUT Format
Notes
8
8
MONO 8
MONO 16
8-in, 8-out
8-in, 8-out
8 bits in 8 LSBs of 16-bit
10
MONO 8
10-in, 8-out
10
MONO 16
10-in, 16-out
12
MONO 8
12-in, 8-out
8 MSB
12
MONO 16
12-in, 16-out
Table 9: Output LUT Availability
X64 Xcelera-HS PX8 Supported Parameters
The tables below describe the Sapera capabilities supported by the X64 Xcelera-HS PX8 (i.e.
default firmware is loaded). Unless specified, each capability applies to both boards or all mode
configurations and all acquisition modes.
The information here is subject to change. Capabilities should be verified by the application
because new board driver releases may change product specifications.
Specifically the X64 Xcelera-HS PX8 family is described in Sapera as:
•
Board Server: Xcelera-HS_PX8_1
•
Acquisition Module: dependent on firmware used
Camera Related Capabilities
Capability
Values
CORACQ_CAP_CONNECTOR_TYPE
CORACQ_VAL_CONNECTOR_TYPE_CX4 (0x8)
CORACQ_CAP_CX4_CONFIGURATION
0x6
Table 10: Camera Related Capabilities
