66
•
Technical Specifications
X64 Xcelera-HS PX8 User's Manual
•
When forwarding the camera data to a 2
nd
frame grabber, connect a short CX4 cable
between the HS-Link Output of the 1
st
frame grabber to the HS-Link input of the 2
nd
frame
grabber. For data forwarding, cable length should not exceed 10 meters.
Contact Teledyne DALSA or browse our web site
http://www.teledynedalsa.com/imaging/products
for the latest information on X64 Xcelera-HS PX8 supported cameras.
Configuration Micro-switches
Three sets of 4 switches are used for user configurations not controlled by software. The following
figure is a typical view of each switch set, shown with the individual switch set in the OFF position.
Following the figure, each of the three switch sets is described. Refer to the board component
layout for their positions (
Connector and Switch Locations
" on page 64)
.
OFF
ON
1
2
3
4
Figure 26: SW1, SW2, SW500 Component View
SW1: General Inputs Signal Switch Point
For each general input, select the threshold voltage detected as a logic high signal.
See
J1: CMD15 Male External Signals Connector
" on page 70
.
SW1
Switch Number
Assigned to
OFF Position
ON Position
(default)
1
2
3
4
general input 1
general input 2
general input 3
general input 4
Logic Transition at
~2 volts
(preferred for
differential
signals)
Logic Transition at
~10 volts
Table 26: SW1 Switches
SW2: Trigger Inputs Signal Switch Point
For each trigger input, select the threshold voltage detected as a logic high signal.
See
J1: CMD15 Male External Signals Connector
" on page 70
.
SW2
Switch Number
Assigned to
OFF Position
(default)
ON Position
1
2
3
4
trigger input 1
trigger input 2
NA
NA
Logic Transition at
~2 volts
(preferred for
differential signals)
Logic Transition at
~10 volts
Table 27: SW2 Switches
