Daktronics OMNISPORT 2000, Руководство по эксплуатации

Страница: 89 / 182

Diving Mode Operation, Menus, & Settings
79
Setup Time-of-Day Menu
This menu is used to set the console’s date and time.
DATE MM/DD/YY
TOD HH:MM:SS*
From Main Menu – [4]>[5]
Press the [0]–[9] keys to enter the correct date and time and then press [ENTER] to save.
Press [CLEAR] twice to exit without saving and retain the previous time and date.
Setup Network Menu
This menu is used to configure various network settings for
outputting Real-Time Data (RTD) to displays and connecting
to Pro Diving software.
Network Enable
This menu sets the ETHERNET jack output on or off. If the jack
is not needed, it can be turned OFF (default).
MENU-NETWORK
NETWORK: ON *
From Main Menu – [4]>[6]>[1]
MENU-NETWORK
NETWORK: OFF*
Use [←][→] to toggle between ON / OFF and then press [ENTER] to save.
Note: If this setting is set to OFF , all of the menus below will be disabled.
IP Address
This menu allows the operator to set or verify the IP address
of the console. The default setting is shown below.
1-STD* 2-CUST
192.168. 0. 55
From Main Menu – [4]>[6]>[2]
In most cases, the standard IP address should be selected.
Press [1] followed by [ENTER] and the display will verify the
console’s IP address. The standard IP address varies by console
name as shown in the table at right.
If a custom IP address is required, such as for connecting to a
non-Daktronics network, press [2] followed by [ENTER] . Press the
[0]–[9] keys to enter a new value for each group of numbers
and press [ENTER] after every group. To select a standard
address instead, press [CLEAR] twice to exit the menu.
Note: Once the console has been successfully connected to a network, it must be
disconnected from the network in order to change the IP address settings.
MENU-SETUP
5-TIME OF DAY
MENU-SETUP
6-NETWORK
MENU-SETUP
1-NETWORK ENABLE
MENU-NETWORK
2-IP ADDRESS
Name IP Address
OMNI1 192.168. 0. 55
OMNI2 192.168. 0. 56
OMNI3 192.168. 0. 57
OMNI4 192.168. 0. 58
IP ADDR- OMNI1
192*168. 0. 55