Daktronics OMNISPORT 2000, Руководство по эксплуатации

Страница: 131 / 182

Track Mode Operation
121
Note: If the operator has not pressed [STORE PRINT] before resetting the timer, pressing
[RESET] will store the race and print the results in addition to resetting the clock.
If the timer was not reset before the start of the next race, refer to Always Ready Start
(p.122) .
Menu
Press [MENU] to access additional functions and setting in the console. Section 12:
Track Mode Menus & Settings (p.125) describes the menus in track mode and how to
navigate them.
Disqualification (DQ)
The DQ (disqualification) flag can be used to disqualify a racer with subsequent re-
ranking on printouts and on the scoreboard.
Typical operation: Press
[DQ] and [LANE ON/OFF] key for the desired lane, or enter the
lane number on the number keypad and press [ENTER] . Doing this sets the DQ flag for
that lane. The DQ operation should normally be done at the conclusion of the race, after
the officials have ruled on the situation that caused the athlete to be disqualified. On exit
from the DQ command, the scoreboard is automatically updated and any subsequent
printouts will show the revised placing.
The DQ operation can be done at any point in the race and does not affect arming or
recording of times for the lane. By pressing the same lane number again while in the DQ
command, the lane is “re-qualified” and the original status indicator is returned. Before
the meet, the timing operator should clarify with the meet referee if he/she wants the
athletes to be disqualified on the timer. Clarification of this is important for results to be
properly ranked on the printouts and meet management software which will show as a
DQ on the scoreboard.
Event/Heat, Home/Guest & Record Time Scoreboards
The Event/Heat Number and Home/Guest Scores can be displayed on the appropriate
scoreboard module if it is included in the system.
When the Event/Heat module is present, the event and heat numbers will automatically
be displayed whenever they are changed with the [EVENT HEAT] key.
When the Home/Guest or Guest/Guest modules are present, the home, guest 1, guest 2
and guest 3 scores will automatically be displayed after being entered in the EDIT-TEAM
SCORE menu. Refer to Edit Team Score (p.127) .
When the Record Time module is present, record data for the corresponding event will
be displayed at the start of the race. One record can be pre-entered for each event in
the EDIT-RECORD TIME menu. Refer to Record Time (p.127) .
Pre-race Setup for the Timer Operator
Printer Setup
Before the start of the first race, the printer should be set up to print the desired
information. Refer to Setup Printer Menu (p.133) to configure the printer.
Verify the Console is Reset
Confirm the console is reset and that RT shows 00:00.0. Set the correct Event Heat and
Lane. Press [NEXT EVENT]>[HEAT +1] / [HEAT -1] or simply press [EVENT HEAT] to enter the
correct Event and Heat.