Daktronics OMNISPORT 2000, Руководство по эксплуатации

Страница: 43 / 182

Swimming Mode Operation
33
1 2 3 4 5 6 7 8 9 10
4 5 + 6 2
4 4 2 5 1
Near End and Far End Touchpad Status
1 2 3 4 5 6 7 8 9 10
+ 4 + * *
3 4 3 6 7

Near End Touchpad Status and Lengths Completed
1 2 3 4 5 6 7 8 9 10
3 4 3 5 7 
4 + 2 * O
Lengths Completed and Far End Touchpad Status
Watch for Accurate Lane Status
Watch swimmers as they touch for splits or finish a race to verify that the correct lane
status is showing. Refer to Getting Started (p.23) to interpret the symbols on the LCDs.
Manual Touch Commands
If necessary, add or subtract touches if swimmers miss the touchpad or have extra
touches. Press [+ TOUCH] or [- TOUCH] then [LANE ON/OFF] at any time during a race to
adjust the length count for an individual lane. Another method is to press [+ TOUCH] or
[- TOUCH] , and use the numeric keypad to input the lane number followed by [ENTER] .
This would normally be done to keep the timer’s internal length count correct if a split
time was missed. Press [CLEAR] to cancel the action any time.
Note: Manual times are marked with a +/- on printouts to distinguish them from normal
touchpad times.
Start
The timer operator watches running time to verify start was received. The timer starts
automatically when the horn start triggers the start of the race. Be prepared to manually
start by pressing [START] if the timer does not start automatically with the horn start’s flash
and tone. If this occurs, the timer operator must notify the meet starter and the meet
referee.
The timer will start any time a start impulse is received. Pressing
[START] may also be used
to start the timer. The printer notes if the start is External or Keyboard.
The OmniSport 2000 console has an internal time-of-day clock that continually runs when
the timer is turned on which allows the always-ready-start feature. The internal clock runs
even when the race clock is stopped.
When a Start is Missed
If a start was missed because the timer was not reset (race clock was still running from the
previous race), the start impulse is logged in the memory and on the printer. To prompt
the operator that a start has occurred, reset the timer. If the operator chooses to use the
received start signal, the timer will automatically start timing the event by calculating the
correct running time. If the timer has already been reset, press [EDIT] to retrieve the start
impulse used for the last race.
3 7 * * +
2 * * * *
 01:37.6
 011  03  P  08
+ 7 + * *
5 4 4 4 3

 01:37.6
 011  03  P  08
5 4 4 4 3 
* + + + +
 01:37.6
 011  03  P  08