Daktronics OMNISPORT 2000, Руководство по эксплуатации

Страница: 71 / 182

Swimming Mode Menus & Settings
61
Lane Module Test
This menu tests the lane module inputs.
[NEAR END DATA
[FAR END DATA
From Main Menu – [5]>[2]
The left and middle LCDs will show the lane module input status by lane. Button feedback
will appear as B1, B2, or B3 in the lane being tested. Touchpad feedback will appear as
TP. All devices should be tested before every session. Press [ENTER] to exit the menu.
Scoreboard Test
These menus check the numeric scoreboard drivers.
Cycle ON/OFF
This menu checks the signal to the scoreboard.
DISPLAY ALL ON
ENTER TO EXIT
From Main Menu – [5]>[3]>[1]
Press [1] to toggle the scoreboard ON and OFF . When this menu is selected, an all ON
signal is sent at intervals of approximately 3 seconds. Press [ENTER] to exit the menu.
Driver Address
This menu shows which addresses each of the drivers on the
scoreboard are set to. The addresses were set when the
display was installed.
SHOWING ADDRESS
ENTER TO EXIT
From Main Menu – [5]>[3]>[2]
Press [2] to display the driver addresses. Press [ENTER] to exit the menu.
Digit Number
This menu shows the digit designation.
SHOWING DIGIT #
ENTER TO EXIT
From Main Menu – [5]>[3]>[3]
Press [3] to display a digit number. The number or letter will show which output on the
driver that digit is plugged into. Press [ENTER] to exit the menu.
MENU-TEST
2-LANE MODULES
MENU-TEST
3-SCOREBOARD
SB TEST MENU
1-CYCLE ON/OFF
From Main Menu – [5]>[3]
SB TEST MENU
2-DRIVER ADDRESS
SB TEST MENU
3-DIGIT NUMBER