DAELIM S2 125, Руководство по обслуживанию

Страница: 134 / 184

●
Repeat the above procedures until no air bubbles
appear in the bleeder hose.
●
Squeeze the bleeder valve and operate the brake lever
to check the ingress of air.
<
When the brake bleeder is not available
>
●
Fill the brake fluid up to the upper limit line.
●
Connect the transparent bleeder hose to the bleeder
valve and place the other end of the hose in a container.
①
Squeeze the brake lever, then open the bleeder
valve 1/2 turn, and close the valve.
②
Release the brake lever slowly and wait several
seconds after it reaches the end of its travel.
③
Repeat the above steps
①
and
②
until bubbles
cease to appear in the fluid at the end of the hose.
●
Check the fluid level often, and add fluid if the fluid
level is near the lower level.
●
If no air leaks out of the bleeder hose, operate the brake
lever to check the presence of air.
●
Tighten the bleeder valve.
TORQUE VALUE : 0.4~0.7 kgf
·
m
●
Be sure that the brake fluid is up to the upper level of
the master cylinder and refill if necessary
●
Reinstall the diaphragm, diaphragm plate and oil cup
cap.
TORQUE VALUE : 1.0 kgf
·
m
12-11
FRONT WHEEL/FRONT FORK/STEERING/BRAKE
브리더 호스
재사용 엄금
브리더 밸브
·
Check the fluid level often, and replenish fluid if the
amount of fluid is reduced to the lower level.
·
Read the user’s manual carefully prior to
disassembling or using the brake bleeder.
·
Protect the bleeder valve with tape to prevent air
from entering the bleeder valve.
·
Do not release the brake lever until the bleeder valve
has been closed.
·
Check the brake fluid level often while bleeding the
system to prevent air from being pumped into the
system.
BLEEDER VALVE
BLEEDER HOSE
NO REUSE