3. Getting Started
This chapter indicates how to use DOT 320 for the first time.
You will begin the DOT 320 by the following steps:
1.
1.
1.
1. Cli
Cli
Cli
Click Reset Button
ck Reset Button
ck Reset Button
ck Reset Button: When using DOT 320 for the first time after unpacking,
battery power is disconnected with DOT 320. Connect the battery power to
device by clicking the Reset Button with stylus pen. In 4or 5 seconds, DOT 320
enters Hardware Reset Mode and loads image in Flash ROM to SDRAM. And
display D.O.Tel company logo and progress bar. You can check loading status
by this progress bar. After loading image, the Main window appears. Now you
can use DOT 320.
2.
2.
2.
2. Connect to battery charger
Connect to battery charger
Connect to battery charger
Connect to battery charger: Connect Battery charger to the DC jack of your
DOT 320. For safe use, you must charge DOT 320 more than 3 hours till
notification LED color turns to orange before using it for the first time. You can
use DOT 320 even when charging.
Warning:
You may lose all data and files if it is entirely discharged. Avoid losing data, you must
control battery not to discharge. IF Notification LED Blinks red, or Battery very low
message appears in display window, charge battery using battery charger before using.
