CyberOptics SE505, Руководство по оборудованию

Страница: 123 / 180

CyberOptics Corporation 113
Conveyor Components
5. Remove the timing belt from the motor drive pulley.
6. Replace with a new timing belt.
7. Thread the timing belt onto the motor drive pulley.
8. Replace the drive pulley of the Auto Width Adjust.
9. Tighten with screws at 6kgf.
➢
To replace the manual width drive belt
1. Turn off all electrical power to the system. For more information, refer to the section
“ Shutting Down the System ” on page 59.
2. Loosen the screw from the wheel plate by using Allen key No. 4.
Figure 75. Wheel Plate
3. Push the wheel plate towards to cylinder direction in order to loosen the tension from the
timing belt.
Figure 76. Wheel Plate and Cylinder