87
2. Setting the duration for the external siren
The duration for the external siren (controlled via the ‘FAZ 3000-SI-2’) is factory set to 60 seconds,
however, you can adjust this time to a value between 10 and 300 seconds.
Caution!
The maximum duration for an acoustic alarm that sounds outside is restricted by law
to 3 minutes (an external flash can signal for longer). This may vary at health resorts,
for example. Therefore, as a precaution, check this out with your local council.
The duration for indoor areas is not normally affected by this restriction. However, if
the internal alarm signal is very loud and is also clearly audible outside, then the legal
restriction may apply here too!
To set the external siren’s duration, proceed as follows:
• You must be on the main level. The LCD should appear as on the right,
for example, with the time and the date.
• Briefly press the ‘
Menü a/A
’ button on the control unit of the ‘FAZ 3000-
Z’ alarm base station.
• Use the ‘ ’ and ‘ ’ buttons to select the ‘
ext. siren
ext. siren
ext. siren
ext. siren
ext. siren
’ menu (‘external
siren’).
• Confirm your selection by briefly pressing the ‘
OK
’ button.
• Select the ‘
dur. siren
dur. siren
dur. siren
dur. siren
dur. siren
’ menu using the ‘ ’ and ‘ ’ buttons (‘siren
duration’).
• Confirm your selection by briefly pressing the ‘
OK
’ button.
The duration that is currently set appears on the LCD (factory set to 60
seconds).
• Use the ‘ ’ and ‘ ’ buttons to select the required duration. You can set
the duration to a value between 10 and 300 seconds (in increments of
10 seconds). To make a quick setting keep the ‘ ’ or ‘ ’ button pressed
for a few seconds.
• Pressing the ‘
OK
’ button applies the setting.
• Exit the menu by pressing the ‘
C
’ button twice. This returns you to the
normal display mode (main level).
ext. siren
troubles
disarm
21:57 08.02
ext. siren
trigger
ext. siren
dur. siren
dur. siren
90 sec.
dur. siren
60 sec.
ext. siren
dur. siren
disarm
22:10 08.02
Содержание FAZ 3000-PIR-2
Страница 115: ...115...
