Conrad Electronic FAZ 3000-PIR-2, Руководство по эксплуатации

Страница: 29 / 115

29
b) Installing the ‘FAZ 3000-TF-2’ door/window detector

One door/window detector is supplied in the set. Additional detectors may be pur-
chased separately.
1. Installation notes
• Magnetic sensors (reed switch) are located inside the ‘FAZ 3000-TF-2’ door/window detec-
tor on the left and on the right side.
This means that you can mount the supplied magnet either on the left or on the right side.

A two-sided installation of 2 magnets (one on the left and one on the right of the door/
window detector) is not possible!
Make absolutely sure that the lower
edge of the magnet is 20mm away from
the lower edge of the door/window
detector.
Mounting the magnet higher or lower
reduces the magnetic range; the mag-
net must be installed closer to the door/
window detector!
The horizontal distance between the
magnet and the door/window detec-
tor should not exceed 25mm. The ideal
distance is approx. 10-15mm.
Tip:
Before using screws to mount the
device, you should first check that it
is working properly so as to avoid
drilling any unattractive holes in the
‘wrong’ location.
• The internal magnet contact (the magnet sensor/reed contact in the door/window detector)
is normally deactivated on delivery. It is activated when closed for the first time via a magnet,
and hereafter signals its state to the alarm base station.

Thus, the door/window detector may also be operated exclusively with external
magnet sensors (without the supplied magnets).
The internal magnet contact can only be deactivated (if it has been activated once already)
by briefly removing the batteries (replacing the batteries) or by deleting and re-registering
the sensor.
Figure 19
max. 25 mm max. 25 mm
20 mm
20 mm