56
b) Testing the sensors
To test the sensors, the ‘FAZ 3000-Z’ alarm base station uses the ‘
run test
’ menu.
In this menu the function of the individual sensors can be tested directly via the alarm
base station’s LCD without triggering an alarm or sabotage alarm. If, for example, you
open the contact of a door/window detector, the sensor name is displayed.
To activate, carry out the following steps:
• You must be on the main level. The LCD should appear as on the right,
for example, with the time and the date.
• Briefly press the ‘
Menü a/A
’ button on the operating unit of the ‘FAZ
3000-Z’ alarm base station.
• Select the ‘
run test
run test
run test
run test
run test
’ menu using the ‘ ’ and ‘ ’ buttons.
• Confirm your selection by briefly pressing the ‘
OK
’ button.
Caution!
Wait at least 10 minutes before you test the sensors’ function and start the
test procedure described below.
The alarm base station must first inform all the sensors that a function test
is to be carried out (status signals between the alarm base station and the
sensors are transmitted approx. every 10 minutes).
Otherwise a situation could arise where a sensor does not send a return
signal to the alarm base station and you then needlessly search for the cause
of the error!
The test procedure is carried out as follows:
• Open the magnetic contact of a door/window detector. The LED on the door/window detector
briefly lights up, and the alarm base station emits a short alarm signal (this may not be audible,
depending on how far you are from the alarm base station).
The magnetic contact can be closed again.
Finally, check the alarm base station’s LCD to see whether the sensor
is functioning and if the alarm base station was notified of the break in
the magnetic contact. See the figure on the right.
If you step across the PIR motion detector’s detection area whilst passing between
the installation location of the door/window detector and the alarm base station, this
will, of course, also trigger an alarm and the previous function notification of the door/
window detector disappears and is replaced by the function notification of the PIR motion
detector. In this case the presence of a second person can be helpful: One person
can test the sensors while the other person checks the function messages directly
on the alarm base station.
disarm
16:55 14.12
troubles
run test
run test
active
contact 1
livingr W1
Содержание FAZ 3000-PIR-2
Страница 115: ...115...
