AO1 / AO2 / AO
2
PolyPanel
ls
8
Connecting Panels to Panels:
A Rod & Block Panel Connector is required to connect two panels in a straight line.
Note: Wherever your furniture plan calls for transaction counters mounted to panels, please
review the section “Transaction Counter Installation” before connecting the panels beneath.
Equal-height Panels:
1. Place top draw block of connector on
top of wedge block of first panel.
2. Loosen the Allen screw in the top
draw block of the connector rod until
the bottom draw block of connector
rod clears bottom wedge block of first
panel.
3. Move and position adjoining panel’s
bottom wedge block adjacent to first
panel’s bottom wedge block within
open half of connector rods bottom
draw block. Then raise the connector
rods draw block and position the
adjoining panels top wedge block next
to the first panels top wedge block,
under the open half of the connector
rods top draw block.
4. Tighten connector rods Allen screw
until panels are securely attached.
5. After assembly of a run of panels,
adjust panel glides in bottom of all
panels to level panel run and to put
equal weight on all panel glides.
Panel End Cap Kit
Use to trim the exposed hardware on the vertical end of a panel at the end of a panel run.
Note: Wherever your furniture plan calls for transaction counters mounted to panels, please
review the section “Transaction Counter Installation” before connecting the panels beneath.
1. Place draw block of the End Cap over the top wedge block of the panel.
2. Loosen
” hex/allen screw at top of End Cap until bottom draw block clears bottom wedge block
of the panel.
3. Tighten hex/allen screw until End Cap is fastened firmly to the panel.
Note: Do not over tighten top Allen screw; it may cause Panel End Cap to bow.
Panel connector
Top wedge blocks
Top draw block
Bottom draw block
Bottom wedge blocks
” Allen
wrench