
AO1 / AO2 / AO
2
PolyPanel
ls
19
Work Surface
Hanger Frame
Screw
Corner Work Surface Installation
Principals apply to both AO1 and AO2. Original AO1-style with retainer strips to locate work surface within cantilever
support arms shown. AO2 utilizes separate ‘button’ and ‘pin’ screws instead of “skate” retainers; “Button” is mounted rear-
most on the work surface and fits into the keyhole slot of the cantilever while “pin” is mounted ahead of the “button” and fits
into the hole just behind the leveling screw at the front top end of the cantilever support arm.
•
Work surfaces include pilot holes for standard location at each end.
•
Load capacity: 200lbs.total load of the work surface, including weight of any component attached to the underside such as a
keyboard tray.
•
Failure to observe the recommend loads and applications will result in unsafe usage conditions which could result in product
failure and/or personal injury.
•
Work surfaces can be adjusted in 1”-inch increments on either panels or wall tracks. Typical work surface heights are:
o
Machine usage/full-time keying: 25” from floor to top surface
o
Sit-down/Typical desk usage: 28” –30”, depending on size of person; 29” most normal
o
Stand-up height: 36”--42”
Set top of cantilever at 1” below desired work surface height
To install cantilever support arms and work surface support bracket:
1. Engage either left-hand or right-hand support arm in the appropriate panel side or wall hanger strip at the desired
height. See illustration. The cantilever support arm must rest fully beneath the work surface and flush to the end.
Important note:
AO
1/AO2
-style support arms and hanging brackets which attach to panels
and wall hanger strips have a built-in anti-dislodgement feature—the bracket ‘teeth’
are curved requiring the bracket to be engaged in the following manner:
a. Tip the top, back of the bracket into the slotted track of a panel or wall
hanger strip so that the top tooth will engage first.
b. Position the bracket slightly offset to the outside of the components
location and, with the top tooth engaged, drop the rest of the bracket
against the slotted channel and into position.
c.
Tap the bracket firmly downward to securely seat the bracket
.
2.
In the same manner, engage the opposite side support arm.
3.
Insert Work Surface Support Bracket (part number HMP455.02) in either panel
slot at the rear corner connector or wall hanger strip, depending on whether the
bracket is a ‘left’- or ‘right’-hand bracket as shown below, right.
Cantilever
Support
Arm