
AO1 / AO2 / AO
2
PolyPanel
ls
22
Shown:
End Support
Pencil Drawer
Drawer Bearers
Work Surface
Transaction Surface Installation
1. Turn out allen screw of finished end top block or panel-to-panel connector draw block, depending
on application.
2. Remove
top
block
or
draw
block and replace with
appropriate transaction counter
bracket.
See description of
each application at right, below
with respective transaction
counter support bracket.
3. Install
connector
or
finished
end as described in “Panel
Installation” above.
4. Position transaction counter over supports and align in
both directions. Attach counter to supports with #12-10
x 1
Flat Head Philips screws.
Pencil Drawer Installation
1. Attach drawer bearers to work surface as
shown at right with flat-head wood
screws supplied.
Note: Closed-end of drawer bearers face
rear of work surface.
2. Use drawer bearer dimensions/spacing
shown below wherever pencil drawer is
desired.
End Support:
Use to replace finished
end top block at the
end of a panel run
which will support a
transaction counter.
Mid End Support:
Use to replace panel-
to-panel connector top
draw block where a
transaction counter
ends at a panel
junction.
Center Support:
Use to replace panel-
to-panel connector top
draw block where a
transaction counter
spans across a panel
junction.
20
”
10”
3 1/8”
front edge