AO1 / AO2 / AO
2
PolyPanel
ls
4
Electrical Power Distribution and Wire Management
Electrical power distribution components are modular and allow complete integration with the
AO
1/AO2
-series furniture system products. Please read and follow this information carefully before
proceeding with any furniture installation requiring electrical components.
WARNING: Disconnect power before servicing any component. Failure to do so can cause
electrical shock and personal injury or property damage.
Electrical power system is:
•
UL-Listed/CSA-Certified and labeled
•
Constructed with shielded conduit to provide an effective built-in EMF barrier
•
Eight-wire, four-circuit design
•
15-amp capacity
•
Three general-purpose circuits
•
One dedicated circuit with isolated ground
Pre-Installation Requirements
The electrical power distribution system is an eight-wire/four-circuit modular system that can supply up to four
circuits with single-phase or three-phase power. Each circuit is rated 125v/15-amps and can supply a maximum
of 13 receptacles.
1. Before starting the electrical component installation, be sure to coordinate the layout with the building
power supply sources.
2. Connection of the electrical components to the building electrical supply
must
be performed by a
qualified electrician.
Installation Preparation
Take care examining contents of each box making sure small packages within boxes are not
overlooked.
1. Sort and stage all items:
•
Panels
•
Connectors and End Trim
•
Wire Management Raceway (AO1 only)
•
Power Components
•
Wall Tracks
•
Cable Poles
•
Work Surfaces and Support Components
•
Overhead and File Pedestal Storage Components
•
Pencil Drawers and Accessories
2. Review building drawings closely to determine exact location of panel runs.
3. Mark floors with chalk lines and/or tape to mark starting points and openings.
4. Start at high point of the floor, if possible.