CommPact Control system, Руководство по установке

Страница: 93 / 148

Appendix B: Transmitter Installation
CommPact Installation Manual
89
DIP Switch Settings
Table B- 1: DIP Switch Settings (EL-2645/EL-2645PI)
Warm-Up Time
The detector will need to warm up for the first 90 seconds after applying power.
Walk Test Mode
A walk test is performed in order to determine the lens coverage pattern of the detector – see Figure
B- 3. Walk Test mode cancels the delay time between detections, enabling you to perform an
efficient walk test.
To perform a Walk Test:
1.
Set DIP 2 to ON.
2. Walk across the scope of the detector according to the detection pattern selected.
3. Confirm that the LED activates and deactivates accordingly. Wait for ten seconds after
each detection before continuing the test.
4. After completing the walk test. Set DIP-2 to OFF.
LED Indication
The LED indicator is lit every time a transmission is made. To enable/disable LED indication, refer
to DIP Switch Setting section for the appropriate DIP-switch setting
LED should only be disabled after successfully walk testing the detector.
Switch Operation
1 PIR sensitivity
*Off : Low
On : High
2
Operation mode :
* Off : Normal mode – Every 3 minutes. After each detection the sensor
initiates a three-minute delay during which alarm transmissions will not be
sent
On : Walk Test mode. An alarm transmission is sent after each detection
3
Supervision Time :
Off : As supervision message will be sent to the monitoring station every 15
minutes
* On : As supervision message will be sent to the monitoring station every
65 minutes
4 LED
Off : LED disabled
* On : LED enabled
*=Default