CommPact Control system, Руководство по установке

Страница: 61 / 148

9 System Options
CommPact Installation Manual
57
Trigger
Option Activated by Deactivated by
Fire Alarm Fire alarm
Zone Status
*
Open zones (steady)
Omitted zones (pulsing)
All zones closed and no zones omitted
Entry/Exit Entry/Exit delay follower
Sounder Built-In Sounder follower
WL Sounder Wireless sounder follower
Telecontrol
Remote PGM activation (PSTN/GSM/keyfob/RP, or via Internet in ELAS versions 321
and above)
For certain trigger options, deactivation may be determined by the PGM Cut-off -- see
p. 58, 9.6.4 PGM Cut-off. If the PGM Cut-off is programmed as 000 (continuous
activation), the PGM output shall remain activated until it is toggled by the relevant
change in system status.
9.6.2. Output Type
The Output Type option determines whether the PGM output produces a steady or pulsed output.
To program the Output Type:
1.
From the Programming menu, select System Options, PGM Options, and Output Type
[94062].
2. Select Steady or Pulsed.
The Zone Status, Sounder and WL Sounder trigger options have a fixed Output Type;
there is no need to program an Output Type for these options.
9.6.3. Polarity
You can determine the polarity of the PGM output from the following two options:
•
Active High: The output is normally off and is switched on when activated.
•
Active Low: The output is normally on and is switched off when activated.
To program the Polarity:
1.
From the Programming menu, select System Options, PGM Options, and Polarity
[94063].
2. Select Active High or Active Low.
*
Zone Status functions only when the system is unset.