CommPact Control system, Руководство по установке

Страница: 37 / 148

4 Advanced System Operation
CommPact Installation Manual
33
4.7.13. Global Chime
The Chime feature causes the Control System’s Built-In Sounder to ring when specific zones are
triggered. Using the Global Chime option, you can enable or disable this feature for all zones that
are defined as Chime enabled – see p.43,
7.3.5 Chime.
To enable or disable Global Chime:
1.
From the Service menu, select Global Chime [712].
2. Select either Enabled or Disabled.
Though the Service menu is accessible to the Master and Engineer only, Global Chime can
also be accessed via a convenient shortcut without needing to enter a valid user code. To
access the Global Chime option from Standby mode, press
then .
4.7.14. Remote Firmware Update
The Remote Firmware Update command enables a user with Master code authorization to initiate
the update. This feature is relevant only if the Remote Firmware Update mode is programmed as
"User Initiated" – see p. 73,
10.8.4 Remote Firmware Update
To grant access to Remote Firmware Update:
•
From the Service menu, select, SW Update [713]; a 24-hours time window is opened
during which the Remote Firmware Update may be performed.
4.7.15. System Reset
System Reset feature can be accessed with Engineer and Master Code. When accessed with
Engineer Code, reset message is registered in the log.
To Reset the System:
•
From the Service menu, select System Reset [714]; the OK? confirmation message is
displayed.