10 Communications
CommPact Installation Manual
71
10.7.2. PIN
Code
The PIN (Personal Identity Number) is a four-digit code that protects the SIM card from
unauthorized use if lost or stolen.
When using a SIM card with an activated PIN code, the engineer has to make sure that the PIN
code programmed in the Control System is the same as the SIM card's PIN code. The PIN code
should be programmed in the system before inserting the SIM card.
To program the PIN code:
1.
From the Programming menu, select Communications, Comm. Options, GSM Options,
and PIN Code [954132].
2.
Edit the four-digit PIN code, and then press '
√ʹ
.
3.
Power up the Control System to apply the new PIN Code definition.
The new PIN code takes effect only after the System is powered.
If a wrong PIN code was programmed in the system, a System Trouble is generated, the
PIN Code
Error
message is displayed, and GSM communication of any kind is not available. In this case, the
SIM card must be reactivated.
To reactivate a SIM card:
1.
Program the correct PIN code in the Control System (see above), then disconnect the
Control System from all the power sources.
2.
Remove the SIM card from the SIM card Holder on the Main Board (see p. 5, Figure
1-2) and
insert it into a cellular phone.
3.
Turn on the cellular phone and enter the correct PIN code.
4.
Re-install the SIM card into the Control System and apply power.
10.7.3. SMS
Center
To edit the SMS Center telephone number:
1.
From the Programming menu, select Communications, Comm. Options, GSM Options,
and SMS Center [954133].
2.
Enter up to 16 digits. Use the
key to enter "*", "#", "," (pause), "T" (switch to DTMF
tone dialing), "P" (switch to pulse dialing) or "+" (international code). Use the
key to
delete one character at a time. Press '
√ʹ
when finished.
10.7.4. SMS
Command
The SMS Command option enables you to enable or disable the ability to send commands to the
system via SMS. For further information on SMS commands, see p. 21,
3.7.3 Remote
Setting/Unsetting via SMS and p. 38,
6.2 Telephone Control.
To enable/disable SMS commands:
1.
From the Programming menu, select Communications, Comm. Options, GSM Options,
and SMS Command [954134].
2.
Select Enabled or Disabled.
Содержание Control system
