CommPact Control system, Руководство по установке

Страница: 131 / 148

Appendix B: Transmitter Installation
CommPact Installation Manual
127
Installing the Detector
1. Remove the mounting bracket from your unit according to Figure B- 43.
1 2 3
Figure B- 43: Mounting the Detector
2. Hold the Mounting bracket against the wall as a template and mark the locations for the
2 mounting holes.
3. Using a 5 mm (3/16-inch) drill bit, drill two holes at the marks and insert wall plugs
(Figure B- 44).
Figure B- 44: Securing the Detector
4. Secure the mounting bracket to the wall.
5. Open the battery cover by pushing down on the battery snaps (Figure B- 45).
+
-
Figure B- 45: Inserting the Batteries
6. Insert the batteries (supplied) into the battery compartment. Pay attention to the correct
battery polarity (+) (-) and close the battery compartment
7. Line up the side slot of the bracket and the detector. Push the detector onto the mounting
bracket until a click is heard (see arrow direction, Figure B- 44).
8. Pull the detector outwards to make sure that it is securely attached to the mounting
bracket.
Transmitter/Receiver Communication Setup
1. Set the panel to registration mode.
2. If you haven’t already done so, insert the batteries into the compartment. The detector
enters registration mode during which a transmission is sent every few seconds. You can
terminate registration mode by pressing the Test Button. Test mode is automatically
terminated after approximately five minutes.
3. Verify that the detector has been identified by the receiver.