CommPact Control system, Руководство по установке

Страница: 62 / 148

9 System Options
CommPact Installation Manual
58
9.6.4. PGM Cut-off
The PGM Cut-off is the duration for which the PGM is activated. Certain Output Trigger types are
deactivated after the PGM Cut-off time has expired– see p. 56, Table
9-1. For those Output Trigger
types that are not affected by the PGM Cut-off, there is no need to program this option.
If, for example, Output Trigger option is set to Full Set, and PGM Cut-off time is 060 seconds; then
PGM is activated by Full Setting and deactivated by unsetting or by PGM Cut-off Time, whichever
comes first. If this option is set to "000" (Continuous activation), PGM is activated by Full Setting,
and deactivated by unsetting.
To program the PGM Cut-off time:
1.
From the Programming menu, select System Options, PGM Options, and PGM Cut-off
[94064].
2. Enter a PGM Cut-off time (001-255 seconds or 000 for continuous activation), then press ' √ʹ.
9.7. "No Set" Indication
The "No Set" indication is a feature designed to inform the central station that the system has not
been set for a specified period of time.
To define the "No Set" indication interval:
1.
From the Programming menu, select System Options, No Set Ind. [9408].
2. Select 1 Week, 2 Weeks, 3 Weeks, 4 Weeks or Disabled.
The No Set event message is an unclassified event. This means that it does not belong
to any event group. If the No Set option is programmed with any option other than
"Disabled", the event message will be sent.
9.8. Jamming Detection
The system is able to detect RF Jamming that is usually caused by an intruder attempting to
compromise the security system.
To program the Jamming Detection setting:
1.
From the Programming menu, select System Options, Jamming Det. [9409].
2. Select Enabled or Disabled.
9.9. "No Motion" Time
The No Motion feature is designed to monitor the activity of disabled or elderly people.
If a detector defined as No Motion (see p. 35,
7.3.1 Zone Type):
•
When the system is unset, and the detector has not been triggered within a pre-
defined period of time (00:00 to 72:00 hours), a No Motion event message is sent to the
central station.
•
When the system is set, this zone behaves as Normal.
The No Motion zone must be included in this setting mode – see p. 42, 7.3.2 Set.
To program the No Motion time:
1.
From the Programming menu, select System Options, No Motion [9410].
2. Enter the No Motion time value between 00:00 and 72:00. To disable the No Motion
feature, enter 00:00. press '
√ʹ .
Time counter is reset each time the system is unset.