Comelit VEDO 2.6 Series, Руководство по программированию

Страница: 78 / 100

78
5. Appendix
5.1 PORT FORWARDING FOR REMOTE CONNECTION
A. For remote management of the Vedo control panel via Safe Manager,
open the router ports card for the IP address of the control panel
network
B. For remote use of the Vedo App, open the router ports to:
• the IP address of the control panel network card.
• the IP address of the first Pal-IP (if present).
• the IP address of the second Pal-IP (if present).
TO B Port
External
port
(default*)
Internal
port
(default*)
Protocol IP Address
√ √
HTTP
(for access to
WEB pages)
80 80 TCP Control
panel net-
work card
√ √
HTTPS
(for secure
access to WEB
pages)
443 443 TCP
√ √
TLS
(for secure com-
munication over
TCP/IP networks)
10022 10022 TCP
√
TCP
(protocol for com-
munication over
TCP/IP networks)
NOT
necessary for
Vedo App
10012 10012 TCP
√
GRAB
(for capturing
screenshots
using the Vedo
application)
30012 10012 TCP First Pal-IP
module
√
STREAMING
(for streaming
data transmis-
sion via Vedo
application)
49110 49110 UDP
√
CSP
(Comelit Signal-
ling Protocol)
24104 24104 UDP
√
GRAB
(for capturing
screenshots
using the Vedo
application)
30013 10012 TCP
Second Pal-
IP module
√
STREAMING
(for streaming
data transmis-
sion via Vedo
application)
49111 49111 UDP
√
CSP
(Comelit Signal-
ling Protocol)
24105 24105 UDP
or
or
The port forwarding procedure is described below:
1. Connect the PC to the router to which the Vedo control panel will be
connected.
2. Access the browser and enter the IP address of the router (this can
be found in the router user manual) in the navigation bar, for example:
192.168.1.1.
3. Log in by entering the username and password (these can be found in
the router user manual).
The port configuration method may differ according to the brand and
type of router used.
4. Search for the sections "Port Opening" or "Apps and games" or "Port
Forwarding" (if not displayed on the main menu, search for them in
Advanced settings) and add the ports you wish to configure.
5. Fill in the configuration panel (see example in the figure below):
a. Enter the name of the port you want to open.
b. Select the desired protocol (TCP or UDP).
c. For the
external port
, enter a desired value which has not been
used for ports opened previously (the value should then be entered
in SafeManager for remote connection on "3.11.1 IP Options"
on page 50 or listed in the Vedo App settings, in the remote
connection parameters section)**.
For the internal port,
enter the default value or the value
configured via Safe Manager software*.
If requested, enter the same value in Start and in End if you wish to
open a single port.
The internal ports corresponding to the Pal-IP modules are
fixed and therefore not freely configurable.
d. Enter the IP address of the device for which you wish to open the
ports on the router (Control panel network card/First Pal-IP module/
Second Pal-IP module).
e. Confirm.
f. Repeat the procedure for each port you wish to open.
* The ports opened on the router must correspond to those
configured via Safe Manager and/or via the App.
** To resolve problems regarding a few router models, we
recommend using an external port value which is equal to the
internal port value.