Communications
Event send settings
Alarm z: Burglar
xxxxxxxxxxxxxxxxx
Tamper:Zone
xxxxxxxxxxxxxxxxx
AC system fault
xxxxxxxxxxxxxxxxx
42
Event send settings
• Activations
This menu is used to program which event activations should be sent to individual recipients. After selecting this menu, the first
group of events is shown at the top of the display (if the FULL MENU option is disabled). There are 16 positions, corresponding to
the 16 recipients, at the bottom of the display.
Depending on the settings of the FULL MENU option, the control panel can list:
- Event groups (if the FULL MENU option is disabled)
- Each individual event (if the FULL MENU option is enabled)
◊ Event groups: After selecting the “
Event activation report
”, the first event group is shown at the top of the display (for
example: Alarms group). There are 16 positions, corresponding to the positions of the addresses of the first 16 recipients,
at the bottom of the display.
- The UP/DOWN arrows are used to navigate to the next event group (or event if the FULL MENU option is enabled).
- The L/R arrows are used to move through the recipient address positions. The current position flashes.
- ENTER is used to alternate between X (to disable the recipient address for the signalling of specified events in that
group) and V (to disable the recipient address for signalling).
- The X key is used to go back up the menu levels.
- This menu level shows the individual events if the FULL MENU option has been enabled.
• Resets: this menu is used to program which even resets should be sent to the individual recipients and follows the sam
programming principles as event activation.
