4.5.1 Submenus for selecting the input type
Depending on the selected input type, the “FUNCTION” button is active and can be used to make various activation choices.
•
LOOP
: select this option when the logic input is an input for a loop device (modules 41IOM010, 41IOM040, 41IOM022,
41IOM122); input terminals are shown as channel numbers.
Press “MORE” to access input programming:
17/06/2020 14:06
1
Group
41IOM122
1
Loop device address
1
Loop number
1
Channel (1,2)
OFF
Sabotage
Loop input parameters
◊
Group
: if necessary, enter the number of the input group
to which the input should belong, between 1 and 250.
◊
Loop device address
: enter the address number of the
device you want to program as an input, between 1 and
250.
◊
Loop number
: enter the Loop number of the device.
◊
Channel
: enter the number of the device input (channel),
to be linked with the logic input; programmable channels
for the module are shown in brackets.
◊
Sabotage
: when the option is enabled (ON), the input is
enabled (true) in the event of a fault condition.
CAUTION: if the device is a detector, a manual button or a module for a conventional zone, the channel
should always be set to “1”; the panel does not allow the value to be changed.
The following alert messages may be shown on the screen:
• "This device can not be used as Input!” - This means that the set device or channel cannot be used as an input.
The message is shown if the set address belongs to a device type that does not have programmable inputs (e.g. Output
modules);
• “Already Used!” - This means that the set device or channel is already being used for other procedures in the panel
configuration.
To save any new parameters, press “Save” on the main input screen.
53
