4.3.3.1 Setting an address
In this submenu the installer can directly assign the addresses to new system devices. The saving procedure is the same as
for sequential addressing. It is recommended when the installer needs to add individual devices to the system configuration,
linking them to free addresses.
The detectors and sounders should not be mounted on the bases; buttons and modules should not be connected
to the loop.
To set the address for a device, select the following sequence:
SYSTEM – PROGRAMMING - DEVICES – ADDRESSING - SET ADDRESS.
The device should be ready for connection to the panel.
17/06/2020 14:06
Set Address
Address
Loop Number
16
1
41SCB100
Save
17/06/2020 14:06
Reset
Outputs
OFF
Set Address
Address
Loop Number
17
1
41SCB100
The system automatically shows the first address in the system. You can check which device is assigned to this address by
pressing the button “TURN ON symbol” - the device LEDs will come on and remain lit steadily. The next time the button is
pressed, they will switch off. Use the
+ & -
buttons to scroll through the addresses and the loop number. The address is free if
the “SAVE” button is active.
Once an available address has been identified, connect the new device to the system: fit the detector or sounder onto the base
or connect the module to the loop via its terminal.
Press “SAVE” and wait a couple of seconds. If addressing was successful, the message “Successful” will appear on the
display. If the message says “Error”, this means there is a problem: the device has not been connected correctly, there is no
communication with the loop expansion.
You can proceed with assigning the next address or exit using the
17/06/2020 14:06
Reset
Outputs
OFF
Set Address
Address
Loop Number
17
1
41SCB100
button.
The installer can reset the device state by pressing the “RESET” button.
The “Outputs” button is activated for devices (sounders) and modules which have relay or monitored outputs. Press the
referenced button to enable / disable the device output status.
48
