17/06/2020 14:06
41IOM010-GAS
Address
Loop Number
Device Zone
3
2
1
Enabled
New
Device State
More
Remove
OFF
Name
Save
17/06/2020 14:06
OFF
Channel 1
ID
2827027013
Enabled
Alarm
To save any new parameters, press “Save” on the main device screen.
41IOM022 – Module with 2 monitored 2 relay outputs with isolator
17/06/2020 14:06
41IOM022
Address
Loop Number
Device Zone
3
2
1
Enabled
New
Device State
More
Remove
OFF
Name
Save
17/06/2020 14:06
0
ON
Sounder Group
Led Blink
Software Revision
ID
2.0
3195011485
The figure shows the settings screen for module 41IOM022.
This module can be used to check its 2 built-in monitored inputs and to control 2 relay outputs.
For further technical information, plus module and input/output line wiring, please refer to the technical manual for this device.
Note: The fire panel recognises “Input 1 as Channel 1”, “Input 2 as Channel 2”, “Output 1 as Channel 3” and “Output 2
as Channel 4”.
Press “MORE” to access additional settings:
•
LED Blink
: select ON/OFF to enable/disable LED indications for the device.
If ON, the LED flashes at every panel dialogue cycle; if OFF, the LED does not flash during the dialogue cycle.
If there is a fault on an input, the field CHANNEL 1 and/or CHANNEL 2 will appear in the MORE menu; faults may be:
•
Open
- The line connected to the input is open, or the double balance resistors are not connected properly on the device
side.
•
Short
- There is a short-circuit in the line connected to the input.
If there are no faults, the following may appear:
•
ON
– the module is present and its input has been enabled.
•
No view
– the module is present and the input is not enabled.
The input or output channel configuration may be programmed via “rapid activation” by directly pressing the button showing
the module model.
37
