Club Car XRT 950 2009, Руководство по техническому обслуживанию и ремонту

Страница: 121 / 256

PERIODIC MAINTENANCE Engine Oil
10
1
2
815
Figure 10-4 Engine Oil Drain Plug and Oil Filter Wrench
Engine Oil Filter Change
1. Drain the engine oil. See Engine Oil Draining on page 10-8.
2. Place the oil drain pan under the engine oil filter (Figure 10-5) .
3. Remove the engine oil filter. Turn it counterclockwise and drain the residual oil in the filter port and filter into
the oil drain pan.
See following NOTE.
NOTE: We recommend using an oil filter wrench of the type shown (2) (Figure 10-4) (Ampro ® P/N T70413785A255 or
equivalent). An oil drip guard can be used to prevent excess oil from dripping onto the engine base plate
(Figure 10-5) . Use an empty quart (one liter) container and cut the bottom off at an angle, then slide the open
area of the container up and under the oil filter before removal. Position the port of the plastic container so
oil will be directed into the oil pan. A drip guard can be made by folding a piece of cardboard, thin metal, or
plastic under the oil filter, forming a channel to direct the filter port oil into the drain pan.
Dispose of used oil according to the environmental laws and regulations for your area.
26
Figure 10-5 Remove Engine Oil Filter
27
Figure 10-6 Coat Rubber Seal
4. Use a clean, lint-free rag to wipe the oil filter port flange surface clean where the oil filter gasket seats.
5. To help seal the new oil filter to the oil port flange, apply a light coat of white lithium NLGI Number 2 grease
(Dow Corning
® BR2-Plus or equivalent) or new engine oil to the rubber seal around the outside surface of the
2009-2012 XRT 950 Maintenance and Service Manual Page 10-9