Club Car XRT 950 2009, Руководство по техническому обслуживанию и ремонту

Страница: 114 / 256

10
Pre-Operation and Daily Safety Checklist PERIODIC MAINTENANCE
WARNING
• Lift only one end of the vehicle at a time. Use a suitable lifting device (chain hoist or hydraulic floor
jack) with 1000 lb. (454 kg) minimum lifting capacity. Do not use lifting device to hold vehicle in raised
position. Use approved jack stands of proper weight capacity to support the vehicle and chock
the wheels that remain on the floor.
• When servicing the vehicle with part of the vehicle on jack stands, do not operate the engine with the
Forward/Reverse handle in either the FORWARD or REVERSE position. The four-wheel drive system
may engage any wheel(s), front or rear, depending on the mode selected. See Figure 1-2.
PRE-OPERATION AND DAILY SAFETY CHECKLIST
Each Club Car vehicle has been thoroughly inspected and adjusted at the factory; however, upon receiving your new
vehicle(s), you should become familiar with the controls, indicators, and operation. Carefully inspect each vehicle to
ensure that it is in proper working condition before accepting delivery.
Use the following list as a guide to inspect the vehicle. This list should be used daily and in conjunction with the
Performance Inspection on page 10-3 and the Periodic Service Schedule on page 10-3 to ensure that the vehicle is in
proper working condition. Any problems should be corrected by a Club Car dealer/distributor or a trained technician.
• General: All the parts should be in place and properly installed. Be sure that all nuts, bolts, and screws are tight.
Check hose clamps for tight fit.
• Safety and information decals: Check to ensure that all safety and information decals are in place and can be
read easily. See Owner’s Manual.
• ROPS: Check to ensure the ROPS is not damaged and all hardware is secure. See ROPS (Roll Over Protective
Structure) on page 4-14.
• Seat belts: Visually inspect for cuts, fraying, and loose parts. See Body and Trim on page 4-1.
• Tires: Check for proper tire pressure. Visually inspect tires for wear, damage, and proper inflation on a daily basis.
See Vehicle Specifications on page 2-1.
• Battery: Check electrolyte to ensure it is at the proper level (Figure 11-8, Page 11-14) . Check battery posts. Wires
should be tight and free of corrosion, and battery should be fully charged.
• Engine: Check for proper engine oil and coolant levels and leaks. See Engine Oil on page 10-7. Check air
filter and replace if necessary.
• Fuel: Check fuel level. See Fueling Instructions on page 10-14. Check fuel tank, lines, fuel cap, pump, and
fuel filters for fuel leakage.
• Exhaust system: Check for leaks.
• Hydraulic brakes: Check fluid level. Fill with DOT 5 brake fluid only. See Brake Fluid Reservoir on page 10-7.
Wear in the brakes before initial vehicle operation. On a flat, open surface, accelerate the vehicle to moderate speed,
then apply the brakes under modest, steady pressure. Repeat this procedure five times.
See following NOTE.
NOTE: Perform the wear-in procedure when the vehicle has been in operation for less than a week, or when the
brake pads or rotor have been replaced.
• Performance Inspection: Inspect as instructed. See Performance Inspection on page 10-3.
Page 10-2 2009-2012 XRT 950 Maintenance and Service Manual