Club Car XRT 950 2009, Руководство по техническому обслуживанию и ремонту

Страница: 124 / 256

10
Gearcase Lubrication PERIODIC MAINTENANCE
2. The rear transaxle is equipped with a fill plug/dipstick (1) located on the top of the rear transaxle (Figure 10-11) .
When the vehicle is on a level surface, use the fill plug/dipstick (1) to determine the lubricant level (Figure
10-12) and (Figure 10-13) .
LUBRICATION CHANGE – FRONT DIFFERENTIAL AND REAR TRANSAXLE
Use the lower plug (2) for drainage (Figure 10-9) and (Figure 10-10) . Remove both plugs to allow the lubricant
to drain faster. See preceding and following NOTE.
NOTE: Metal particles may be discovered in the fluid or on the magnetic drain plug when changing the differential or
transmission fluid. These particles are normal and expected for the first few fluid changes. This is a result
of the gears being “net forged,” meaning the gears are forged to a shape very close to the final gear size
but the teeth are not finish machined prior to assembly. The “finish machining” occurs when the gears make
contact under load during vehicle operation. The magnetic drain plug is included in the design to collect
the metal particles generated from the gear break in process. This is an established process and is not
detrimental to gear service life.
Front differential:
1. Clean and install the drain plug (2) and washer before filling the front differential with new lubricant (Figure
10-9) . Tighten the drain plug to 106 in-lb (12 N·m).
2. Use a funnel when filling the front differential through the lubricant level indicator hole (1). See Periodic
Lubrication Schedule on page 10-6.
3. Tighten the level indicator plug to 10 ft-lb (14 N·m).
1
2
807
Figure 10-9 Front Differential Lubrication
Rear transaxle:
1. Clean and install the drain plug (2) and washer before filling the rear transaxle with new lubricant (Figure 10-10) .
Tighten the drain plug to 8 ft-lb (10.8 N·m).
2. Remove the fill plug/dipstick (2) (Figure 10-12) . Use a funnel and tube to fill the transaxle through the fill
plug/dipstick hole (1) located on the top of the rear transaxle (Figure 10-11) . See Periodic Lubrication
Schedule on page 10-6.
3. Replace rear transaxle dipstick and tighten to 35 in-lb (4 N·m).
Page 10-12 2009-2012 XRT 950 Maintenance and Service Manual