Club Car XRT 950 2009, Руководство по техническому обслуживанию и ремонту

Страница: 145 / 256

TROUBLESHOOTING AND ELECTRICAL SYSTEM Test Procedures
11
1022
Figure 11-10 Frame Ground Cable
1021
Figure 11-11 Engine Ground Cable
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK 5XL
V
V
V
A
! !
COM
200nA
MAX
1000 ---
750V
FUSED
2
3
1
1. Disconnect the 6-gauge black wire from the battery. Place red
(+) probe on disconnected end of cable.
2. Place black (–) probe on frame.
1600-19700-10373
Figure 11-12 Battery Ground Cable Test
TEST PROCEDURE 4 – Key Switch (Starter Circuit)
See General Warning on page 1-2.
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page 1-4.
2. Raise the hood and remove the access panel.
3. Ensure that the key switch connector is connected correctly and is tight. If it is not, repair or replace as necessary.
4. Remove the key switch. See Key Switch Removal on page 12-7.
5. Set the multimeter to 200 ohms.
6. Turn the key switch ON. Place the red (+) probe of the multimeter on the (B) terminal and the black (–) probe
on the (L) terminal of the key switch. The reading should indicate continuity. If the reading does not indicate
continuity, replace the key switch
(Figure 11-13, Page 11-18) . See Key Switch Installation on page 12-7.
7. With the key switch still in the ON position, place the red (+) probe of the multimeter on the (B) terminal and the
black (–) probe on the (S) terminal of the key switch. The reading should indicate no continuity. If the reading
indicates continuity, replace the key switch.
See Key Switch Installation on page 12-7. If the reading does not
indicate continuity, leave the probes connected and proceed to step 8.
2009-2012 XRT 950 Maintenance and Service Manual Page 11-17