Club Car XRT 950 2009, Руководство по техническому обслуживанию и ремонту

Страница: 55 / 256

ACCELERATOR AND BRAKE PEDAL GROUP Accelerator Cable Removal – From Early-2012 Model Year
5
ACCELERATOR CABLE REMOVAL – FROM EARLY-2012 MODEL YEAR
See General Warning on page 1-2.
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page 1-4.
2. Raise the cargo bed and engage the cargo bed lock pin (1) located at the driver side cargo bed hinge (2) (Figure
5-22, Page 5-11) .
3. Remove the two screws securing the heat shield to the exhaust manifold (Figure 5-23, Page 5-11) .
1
2
1. Locking Pin 2. Bed Locking Pin Holes
K-00221
Figure 5-22 Bed Locking Pin
1023
Figure 5-23 Remove Exhaust Heat Shield
4. Loosen the jam nuts that secure cable to engine (Figure 5-24, Page 5-11) .
5. Unhook spring end of accelerator cable from throttle bellcrank.
6. Under the front cowl, disconnect the Z-shaped end (1) of the accelerator cable from the pedal (2) (Figure
5-25, Page 5-11) .
7. Compress the tines (3) of the cable anchor (4) and pull the cable from the mounting bracket (5).
8. If equipped, note location and number of wire ties securing cable to chassis. Cut wire ties and remove cable.
2
1
3
4
5
2509
Figure 5-24 Disconnect Cable At Engine
2510
Figure 5-25 Disconnect Cable At Pedal
2009-2012 XRT 950 Maintenance and Service Manual Page 5-11