Club Car XRT 950 2009, Руководство по техническому обслуживанию и ремонту

Страница: 45 / 256

SECTION 5 – ACCELERATOR AND BRAKE PEDAL GROUP
5
DANGER
• See General Warning on page 1-2.
WARNING
• See General Warning on page 1-2.
ACCELERATOR PEDAL REMOVAL – THROUGH EARLY-2012 MODEL YEAR
See General Warning on page 1-2.
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page 1-4.
2. Remove the under-pedal closeout panel. Drill out rivets and carefully pull the panel out and down over the
pedals.
(Figure 5-1, Page 5-1)
CAUTION
• Be sure not to damage any components as a result of the drilling operation.
3. Disconnect the Z-shaped end (1) of the accelerator cable from the pedal (Figure 5-2, Page 5-1) . See following
NOTE.
NOTE: If the accelerator cable does not have enough slack to allow disconnection at the pedal, it may be necessary
to disconnect the accelerator cable at the engine.
1179
Figure 5-1 Pedal Group – closeout panel
952
Figure 5-2 Pedal Group – accelerator cable at pedal
4. Raise the cargo bed and secure with the bed locking pin (Figure 5-3, Page 5-2) . See Cargo Bed, Section 4,
Page 4-20.
5. Remove the exhaust pipe heat shield (Figure 5-4, Page 5-2) .
2009-2012 XRT 950 Maintenance and Service Manual Page 5-1