Club Car XRT 950 2009, Руководство по техническому обслуживанию и ремонту

Страница: 155 / 256

TROUBLESHOOTING AND ELECTRICAL SYSTEM Test Procedures
11
The neutral switch is located on top of the transaxle housing. Remove load from cargo bed first, raise bed and secure
bed in raised position with bed locking pin.
See Cargo Bed Removal, Section 4, Page 4-20.
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page 1-4.
2. Disconnect the two-pin connector between the neutral switch and the wire harness (w138 and w143) (Figure
11-34, Page 11-27) .
3. Check continuity of the switch contacts with the Forward/Reverse handle in the FORWARD position. The
multimeter should indicate no continuity.
4. Check for continuity on the switch contacts with the Forward/Reverse handle in the NEUTRAL position. The
multimeter should indicate continuity.
1143
Figure 11-34 Neutral Switch (2–Pin Connector)
1153
Figure 11-35 Test Neutral Switch – Neutral Position
1152
Figure 11-36 Test Neutral Switch – Forward or Reverse
Position
5. Check continuity of the switch contacts with the Forward/Reverse handle in the REVERSE position. The
multimeter should indicate no continuity.
6. If any of the continuity readings are incorrect, replace the neutral switch. See Warning Light Removal on
page 12-5.
2009-2012 XRT 950 Maintenance and Service Manual Page 11-27