10
Engine Oil
PERIODIC MAINTENANCE
3
2
1
1. Full Level 2. Safe Level 3. Low Level
1
804
Figure 10-2
Engine Oil Level Check
818
Figure 10-3
Center Access Panel
ENGINE OIL AND FILTER CHANGE
Engine oil and oil filter should be changed after the first 5 to 8 hours of operation. After that, the oil should be changed
every 100 hours of operation or annually, whichever comes first.
Engine Oil Draining
1.
Disconnect battery and spark plug wire(s).
See Disconnecting the Battery – Gasoline Vehicles on page 1-4.
2.
Raise the cargo bed, locate and remove the center access panel (1)
3.
Remove the oil filler cap to allow the oil to drain properly.
4.
Position a pan designed for oil changes under the drain plug.
5.
From the underside of the vehicle, use a socket or wrench to remove the drain plug (1)
. Turn the
plug counterclockwise and drain the engine oil into the pan.
See following WARNING.
WARNING
• Do not attempt to change engine oil when the engine is hot or even warm. Hot engine oil can burn skin.
• Wear safety glasses or approved eye protection when servicing the vehicle. Wear rubber gloves when
handling oil drain plug, oil filter, and oil drain pan.
6.
Clean the oil drain plug threads with solvent to remove oil and oil residue. Make sure that the compression
washer or sealing o-ring remains on the drain plug. Inspect the compression washer or the sealing o-ring
and replace if necessary.
7.
Use a socket or wrench to replace the oil drain plug (1)
. Turn the plug clockwise and tighten to
14.5 ft-lb (20 N·m).
8.
Replace the oil filler cap.
9.
Replace the center access panel (1)
, then lower and latch the cargo bed.
Page 10-8
2009-2012 XRT 950 Maintenance and Service Manual
Содержание XRT 950 2009
