Club Car Precedent 2014, Руководство по техническому обслуживанию и ремонту

Страница: 52 / 548

4
Rear Body – Two-Passenger Vehicles BODY AND TRIM
REAR BODY COMPONENTS (TWO-PASSENGER)
Rear Beauty Panel Removal
1. Remove SAM. See SAM Removal on page 4-12.
2. Remove one screw (3) from each canopy support bracket (1 and 2) (Figure 4-11, Page 4-15) . Remove canopy
supports.
3. Remove four screws (13) attaching the rear beauty panel (12).
4. Remove two screws (14) and remove Forward/Reverse switch housing (15) from vehicle.
5. Disconnect electrical wires from the Forward/Reverse switch (16).
6. Disengage the two body clips (17) under the rear of the beauty panel from the slots in the rear underbody (4).
7. Lift rear beauty panel (12) from vehicle.
Rear Beauty Panel Installation
1. Install rear beauty panel (12) on vehicle. Make sure body clips (17) on the rear of the beauty panel engage
the slots in the rear underbody (4)
(Figure 4-11, Page 4-15) . Secure beauty panel in place with four screws
(13). Tighten screws to 44 in·lb (5 N·m).
2. Connect the three wires to the Forward/Reverse switch (16) as shown.
3. Position the Forward/Reverse switch housing (15) on the front of beauty panel (12) and secure with two screws
(14). Tighten screws to 20 in·lb (2.3 N·m).
4. Position canopy support brackets (1 and 2) on vehicle and secure each with one screw (3). Tighten screws to
53 in·lb (6 N·m).
Access Panel
Access panel (6) is secured to the rear underbody (4) with two push rivets (7) (Figure 4-11, Page 4-15) .
Rear Underbody Removal
1. Remove four screws (5) attaching the rear underbody (4) to vehicle (Figure 4-11, Page 4-15) .
2. Lift the rear edge of the rear underbody (4) until the front portion slides out from beneath the front underbody.
Remove the rear underbody from the vehicle.
Rear Underbody Installation
Install rear underbody (4) on the vehicle (Figure 4-11, Page 4-15) . Install four screws (5) to secure the underbody
to the vehicle. Tighten screws (5) to 71 in·lb (8 N·m).
Rear Crossmember Removal
Remove bolts (10) to release rear crossmember (18) from vehicle (Figure 4-11, Page 4-15) .
Rear Crossmember Installation
Position rear crossmember (18) on vehicle and secure with bolts (10) (Figure 4-11, Page 4-15) . Bolts (10) thread
into J-clips (11) attached to the inner-frame rail. Tighten bolts to 56 in·lb (6.35 N·m) for two-passenger vehicles or
123 in·lb (14 N·m) for four-passenger vehicles.
Page 4-14 2014 Precedent ® Golf Car Maintenance and Service Manual